Introduction

Generally there are two ways of checking emails. POP3 downloads your emails from the email server of the university to your computer. IMAP leaves the emails on the server and you can only check them locally. If you only use one PC to check your emails, the best option is to choose POP3. If you have several computers to check your emails, choose IMAP. Please not that with IMAP an Internet connection is always necessary when you want to check your emails.

Configuration of Thunderbird for the checking of emails

1. Start Thunderbird and set up a new email account. This is done by choosing the item “account” in the menu “Extras”. You will now see the account administration as shown in the image below. Now click "add account".

• Open the account administration:
  

2. In the following menu dialog choose "Email-account", because you want to set up a new email account. Next you will be asked for your name and email address. Now enter your full name and your university email address.

• Add a new account:
  

3. The following dialog asks you for the way in which you would like to check your emails. As described in the introduction, you should use the POP3, if you intend to check your emails on one computer only. Use IMAP, if the emails will be checked on more than one computer and those computers are always connected to the Internet. The two images below show the settings for each method.

• POP method:
  
• IMAP method:
  

4. In the next dialog enter your user name. This is the same user name that you take to log into university computer workstations. Then you will be asked to provide a name for the account. A good suggestion is "Uni Mails".

• Enter user name:
  

5. The last page sums up all the settings. The "finish" button completes the assistant.

6. The assistant is now complete. But in order to be able to check your emails, you must adjust the encryption of the data transfer. In the open „accounts“-window, choose the server-settings on the left of the account that you have just set up. If you have proceeded according to the instruction, the correct account is called "Uni Mails". Under the section "Security and Authentication" activate the SSL encryption. All other options have already been adjusted correctly. The two images below again show the right settings for POP3 and IMAP.

• Activate POP3 SSL:
  

• Activate IMAP SSL:
  

7. The configuration of the POP3 mailbox is now complete and you can proceed with the configuration of Thunderbird for the sending of e-mails If you have opted for an IMAP mailbox the ZIV recommends having the following advanced settings. This way you can avoid the risk of damaging your mailbox unintentionally. Confirm with the button "Advanced". Adjust the settings in the following window as shown in the image below.

• Advanced settings IMAP:
  

Configuring Thunderbird for the sending of emails

The sending of emails is done via a different server. Therefore, it must be configured separately. Once more open the account administration via the menu item Extras -> accounts. Now choose „Outgoing mail server (SMTP)” in the left menu bar of the starting dialog. As shown in the image below you can now set up a new outgoing mail server by clicking the button „add“ in the right part of the window.

• New SMTP account:
  

After clicking the button, you will see the dialog shown below. Take the same settings as the ones shown in the image below. As user name choose your own user name. It is identical with the one you usually take to log into university computer workstations.

• SMTP settings:
  

-- MatthiasSchelp - 11 Jun 2008

Troubleshooting/notes

If you found errors or problems in this manual that only concerns part of the users of this tutorial, enter your experiences and suggestions for improvement here. If the problem concerns all the users of this manual, you may make the necessary chances directly..

The advanced IMAP-settings are incorrect; see added notes framed red -- RainerPerske - 2009-12-01